10-8 Performance Visier Glock Rear Sight, Low Profile, Standart Height

Descrizione di 10-8 Performance Visier Glock Rear Sight, Low Profile, Standart Height

Notch Width
.140"

Description
Our Low Profile Glock Rear Sight includes our new Gen2 feature set:

Scooped shoulders for improved downrange awareness
Deeper .125" notch
Wider dovetail base for better fit in new production Glocks and aftermarket slides
Serrated front face for better traction during one handed manipulation
Standard height (.325" overall height, .250" above the slide), designed to fit into ALL Glock slides without interfering with the factory MOS cut. This sight is compatible with our normal .215"-.250" tall Glock front sights.

**This is our recommended rear sight for the Glock 43x/48/43xMOS/48MOS, in conjunction with our .250" height Glock front sight.**

**This is our recommended rear sight for the Glock 44 (.22 cal), in conjunction with our .235" height Glock front sight.**

Notch: .140" and .156" wide U Notch
.140" - good balance of speed and accuracy
.156" - good for maximum speed, preferred for older eyes
Notch is .125" deep
Compatible with .215" - .250" tall front sights (see below for more info)
Our rear sight is .250” net blade height above the slide
Use a notch width equal to or greater than front sight width.
NOT compatible in elevation with the Glock OEM, Trijicon OEM style, TruDot, Meprolight, TruGlo TFO front sights as they are too low.
XS Standard Dot front sights are .200" tall. Our .156" notch rear is recommended, but we do not guarantee POA/POI due to the short height.
XS Big Dot front sight is .195" wide, and is too wide to work with any our sights.
Trijicon HD, GL101 Series front sight is .215" tall x .144" wide. Our .156" notch rear is compatible.

Fitting is usually not required, but Glock slide dovetails have varied significantly during production and sometimes the sight won't drift in without some fitting. The QPQ/Melonite finish of these sights is harder than a normal steel file. If the sight is too tight and needs to be filed, use a diamond file or hone (see Brownells.com), as files will slide right off the surface.

Finished in black QPQ salt bath nitrocarburizing (aka Melonite, same as the Glock slide), includes set screw and wrench.