10-8 Performance Glock Front Sight, Fiber Optic .235h x .125w Fiber Optic
Description de 10-8 Performance Glock Front Sight, Fiber Optic .235h x .125w Fiber Optic
Description
Precision CNC machined from hardened 4140 tool steel and finished in black QPQ salt bath nitrocarburizing (aka Melonite, same as the Glock slide).
Fits: ALL Glock models, all calibers, all frame sizes, all slide sizes.
Fiber optic (.060" rod with .075" diameter counterbore on 40lpi serrated blade face for flared bulb).
Compatible with .250" blade height rear sights. NOT compatible with Glock factory rear sights, fixed or adjustable, as they are shorter than .250" blade height.
Height: .215", .235" and .250"
ALL Glock models, regardless of size, caliber, or generation, most commonly use the .215" front.
Glock 34/35, 41, 17L, 24L most commonly uses the .235" front. Sights do not overhang slide cutout.
Glock 48 uses .250" front with our Glock MOS Standard Height Rear Sight.
The .235" front lowers impact approximately 2-3" at 25 yards relative to the .215" front.
The .250" front lowers impact approximately 3-5" at 25 yards relative to the .215" front.
Please note that different guns will vary in regards to point of impact, especially with differing shooter preference. These heights are recommendations, and we cannot guarantee point of impact due to variations in individual guns. Point of impact will vary by *individual gun* and not so much by generation.
Width: .125", .115"
Blade width is strictly personal preference. Thinner fronts cover less of the target area and are preferred for speed. Thicker blades like the .125" are preferred for improved accuracy and are our most popular.
All sights include set screw and one section each of red and green .060" fiber optic rods.
**INSTALL ONLY TO MAX TORQUE OF 6 INCH/LBS or else you may risk cracking the threaded post.
***Due to manufacturing tolerances by our fiber optic supplier, there may be slight variation in the diameter of the fiber optic rod. Use a razor blade or X-Acto knife at 90 degrees to the rod and gently scrape the outside diameter a little bit and it will fit right in without any compromise to the function.
